You then put another 1/8″ drill, or dowel in this hole. I then use the pillar drill to drill the 6 thru holes. Flip your guitar over and place one of the holes you drilled on the top, onto this dowel. Essentially I'm still putting my pillar drill to work, since it's the nearest thing I'm going to get to a vertical hole, but I'm drilling 6 holes into a flat piece of scrap timber that I'm going to use as a guide or jig. You now know that the drill press is perfectly lined up with the hole on the front and you can now drill the rest of the way through. You can see from this video that this approach will give a good result even while holding both guide block and drill by hand only. The 'throat depth' on my pillar drill is about 1mm too short to allow me to use it to drill these 'string thru' holes in the custom Strat I'm making. But I did it this way to show that with a little downward pressure on the guide block you can drill a vertical hole in the workpiece. The 'throat depth' on my pillar drill is about 1mm too short to allow me to use it to drill these 'string thru' holes in the custom Strat I'm making. I reproduced the bridge footprint at the front edge of the scrap block with carefully measured and marked edge points and centre point. Take your time and it's easy! When Leo Fender introduced his revolutionary solidbody guitar in 1950, it had strings anchored in ferules (small metal cups) inset into the back of the guitar and passing up through holes in the body and through the bridge plate, where they took a right-angle turn over … If you want to be even more careful you can ensure the workpiece and the guide block are clamped leaving only the hand-drill to be used 'free-hand'. Anyone who has tried this by hand in the past will know that no matter how hard you try, those exit holes will be all over the place. With those, you actually drill holes for the strings to pass clear through the guitar’s body. How To Drill String Through Holes In A Guitar Body - YouTube Here's my 'on-the-fly' way around the problem. The “Vintage” bridge uses four mounting holes between the string holes and the neck and a 2.125” string spacing; the “Modern” bridge uses three holes with the string holes between the neck and the mounting holes and a 2.08” string spacing. Now unless you have a stand-alone pillar drill support that you can use with your mains or battery-powered hand drill you'll need to come up with some way to ensure that your string-thru holes exit the guitar body in a straight line. Although my holes didn't go all the way through the workpiece, the first part of the hole then served again as a vertical guide to let me safely finish the hole and exit carefully out the back. When I'm happy they're perfectly spaced I can then prepare to use them as a guide for my hand-drill. the second Patreon video request on how to drill string through holes without a drill press.

Mad Minis Walmart, Methylene Chloride-based Remover, Jeskai Voltron Edh, Fender American Professional Telecaster Olympic White, Noaa Mammoth Lakes, Eight Theories Of Religion, Is There Any Pressure On Us To Buy Presents Ielts, Crossbill In Flight,